Whirlpool · Washing machine

F5E1

Power reset only

error code

Whirlpool F5E1 is a front-load washer door-switch error.

Market, product family, and model applicability

US · en-US · Whirlpool front-load washers covered by the cited US Product Help article

product family applicable: The official source applies at the product-family level. Exact controls can still vary by model.

Close the door fully, remove clothing or shipping material blocking the switch, and disconnect power for five minutes before reconnecting.

Close the door completely and remove clothing or shipping material blocking the switch.
Disconnect the washer from power for five minutes, then reconnect it.

Contact Whirlpool or schedule service if the exterior check and power reset do not resolve F5E1.

Do not access the door switch or internal wiring, and do not shut off water unless an exact model manual separately directs it.

Do not access the door switch or internal wiring; use the exterior checks and power reset only, then schedule service if needed.

If F5E1 remains after the documented checks and reset, contact Whirlpool or schedule service.

Official manufacturer source

Market and locale: US · en-US
Product family: front-load washers
Official source last checked: July 22, 2026
Review status: Automated evidence review completed · Owner-delegated approval

Whirlpool

F5 E1 - Front Load Washer · Official support article

Send a privacy-minimal correction signal. It cannot change public content automatically.

Same model family

Whirlpool · Washing machine

error code

Power reset only

Whirlpool F7E1 indicates that a front-load washer's motor cannot reach the speed required for the selected cycle.

Need a different display? Return to the decoder.