Maytag · Washing machine
Int
Power reset onlystatus message
Maytag Int is a status shown while a paused or canceled washer cycle is stopping and draining.
Market, product family, and model applicability
US · en-US · Maytag front-load washers covered by the official Product Help table covered by the cited official US support page
product family applicable: The official source applies at the product-family level. Exact controls can still vary by model.
Check the official model/manual lookup (opens in a new tab)What you can do now
Wait for the drain routine, then press Pause or Cancel twice and Power once; disconnect power for five minutes only if the display remains.
- After the drain routine, press Pause or Cancel twice and Power once.
- If Int remains, disconnect washer power for five minutes, then reconnect it.
Stop and get service when
Contact Maytag if Int remains after the documented reset.
Do not do
Do not interrupt the drain by opening the washer.
Use only the documented controls and power reset.
If the message returns
If Int remains, contact Maytag.
Source and scope
Official manufacturer source- Market and locale
- US · en-US
- Product family
- front-load washers covered by the official Product Help table
- Official source last checked
- July 25, 2026
- Review status
- Automated evidence review completed · Owner-delegated approval
Maytag
Error Codes in Front Load Washers · Official error-code index
Open official source (opens in a new tab)Does the model or source look wrong?
Send a privacy-minimal correction signal. It cannot change public content automatically.
Report a model or source mismatchNeed a different display? Return to the decoder.