LG · Dishwasher
FE
Power reset onlyerror code
LG FE means the dishwasher detected too much water and turned on its drain pump.
Market, product family, and model applicability
US · en-US · LG dishwashers covered by the US Help Library index covered by the cited official US support page
product family applicable: The official source applies at the product-family level. Exact controls can still vary by model.
Check the official model/manual lookup (opens in a new tab)What you can do now
Turn the dishwasher off, switch its breaker off for ten seconds, restore power, and start a new cycle.
- Switch the dishwasher breaker off for ten seconds, then restore power.
- Turn the dishwasher on and start a new cycle.
Stop and get service when
Request LG repair service if FE persists.
- Request LG repair service if FE persists.
Do not do
Do not open the dishwasher or service internal fill or drain components.
Use only the breaker reset; do not access the fill or drain system.
If the message returns
If FE persists after the reset, request LG repair service.
Source and scope
Official manufacturer source- Market and locale
- US · en-US
- Product family
- dishwashers covered by the US Help Library index
- Official source last checked
- July 22, 2026
- Review status
- Automated evidence review completed · Owner-delegated approval
LG
LG Dishwasher – Error Code List · Official error-code index
Open official source (opens in a new tab)Does the model or source look wrong?
Send a privacy-minimal correction signal. It cannot change public content automatically.
Report a model or source mismatchNeed a different display? Return to the decoder.