Appliance Code Check

GE Appliances · Range or wall oven

F350

Professional service required

fault code

GE says F350 usually indicates an upper cooling-fan circuit issue or a cooling-fan obstruction.

Market, product family, and model applicability

US · en-US · GE Appliances ranges and wall ovens with electronic controls covered by the cited US index

product family applicable: The official source applies at the product-family level. Exact controls can still vary by model.

Check the official model/manual lookup (opens in a new tab)

What you can do now

Use only GE's documented breaker reset; do not inspect or replace internal components.

  1. Turn off the range or wall oven at its circuit breaker or fuse for one to two minutes, then restore power.

Stop and get service when

A trained service technician should diagnose and correct the fault if the breaker reset does not clear it or it returns.

  • If the code remains, keep the range or wall oven off at the circuit breaker until it is serviced.
  • Schedule GE Appliances service if the control does not reset or the code returns.

Do not do

Do not replace the sensor, keypanel, fan, lock, control, wiring, or other internal parts from this guide.

GE directs fault diagnosis and correction to a trained service technician and recommends keeping the appliance off until serviced when the control does not reset.

If the message returns

If the code remains after the one- to two-minute reset or returns, keep the appliance off and schedule GE Appliances service.

Source and scope

Official manufacturer source
Market and locale
US · en-US
Product family
ranges and wall ovens with electronic controls
Official source last checked
July 22, 2026
Review status
Automated evidence review completed · Owner-delegated approval

GE Appliances

Range & Wall Oven - Oven Error, Fault or Function Codes · Official error-code index

Open official source (opens in a new tab)

Does the model or source look wrong?

Send a privacy-minimal correction signal. It cannot change public content automatically.

Report a model or source mismatch

Need a different display? Return to the decoder.